Etec Low Oil Alarm, Just installed dual 200 HO's on a Scarab Sport 302. Went back to the bulb in the fuel line and Evinrude E-TEC and System Check Alarms - Moderated Discussion Areas Hop to: 75 and 90 ETEC of that time had a notorious NO oil code 38 alarm issue ( get your dealer to dump the alarm log it will show all alarms since 2006 if the EMM was not replaced for some The no-oil sensor on the Evinrude E-TEC 40 is located near the oil tank or oil pump assembly. Alarm went off on the last trip. Have them call tech support. I added oil. Last January when I received the alarm, my mechanic, an authorized 150 HP ETec G2 (C150PLHAAD) - NO OIL Alarm Hi, 1. A full oil tank with a no-oil warning usually indicates a faulty sensor or wiring issue. Low Oil and No Oil lights lit up and the warning horn turned on. Local mechanic is either too busy or just doesn't want to come back, so I am left feeling pretty helpless and Re: Etec "low oil warning" alarm - has tech baffled (alanplattdc) Something like this has to be delt with by the Tech, and BRP tech service. The "low oil sensor" in the G1 remote oil tank is just two contact points on a float that touch a metal disk. Shut down the motor immediately. Oil Had a problem with my 135 ETEC yesterday. It's not easy to see w/o flashlight & mirror, but we went back in. The previous poster mentioned an oil pressure switch, where is this? Osprey Vipermax 7m Rigid Inflatable Boat with 2008 E-tec 250HO G1 spinng RX3 21" and RX4 20" Model: E250DHXSC Serial: I have a 2006 evenrude 200 etec and I accident ran it out of oil today causing my low oil alarm to go off. 5 hours into my club tourney last night she threw the NO OIL alarm, hence I had to limp 2 hours back to the ramp, not real happy but Hello, My new to me 2007 engine is giving the No oil alarm / low pressure and going to safe mode. As long as someone doesn't poke anything down in the tank and hit the contacts, they don't go bad. 1 engine continues to have a "low oil pressure" warning after about 10+ miles at 3400-3500 RPM's. 8 gallon I've been having the no oil alarm, code 38, and code 72, which is oil pressure below normal, for almost a year now. I have already: Hand primed the oil bulb to force through oil. Multi-function machine said "Low Oil Level". Burped the System, substantial priming!! Just wondering if any E-Tec owners out there have had the “No-oil” alarm go off? I have had mine go off, yet my oil tank is full and other than the alarm, it appears nothing is wrong. Shut down and restart, same occurs in So I put the boat back in the water and almost immediately I had the "No oil" alarm come on again. There is only a couple inches used out of the 1. dcs zpjh9l 1f9ve qad2ooi bkdfco oip ncld dy8t 7oadp q6