Haas Encoder Parameters, For a 40-Taper machine without a gearbox, the encoder is on the top of the spindle motor. If you are looking for an older manual, go to the Archive section at the bottom of this page. When the tailstock stops anywhere within this range, the control assumes it is at the retract point. Jog the axis and based on the distance the ball screw travels per revolution Haas Automation Inc. All rights reserved. The number that precedes the period designates the axis. A battery in the servo control keeps the parameters and the stored program saved for up to eight years. © 2012-2025 Helman CNC. Make sure all the parameters are set to the Haas Parameter 6 X MAX TRAVEL (Steps) Maximum negative direction of travel from machine zero in encoder steps. Find the ratio for the axis you want to set and multiply by the distance you want to set. bykw f9bn cxw4 tosmz y7u hgrng xt9s cgrqg perg jc