Unraid Parity Emulated, I switched SATA ports and SATA Hello, I have a problem, one disk is disabled because of read errors (emulated). This is because there COULD have been new data written to this "emulated drive" Hey there! I've been running unRAID for some years now and have been getting better at administration, but, as I'm maxed out on power and space in my case I'm at a bit of a conundrum. I thought I fixed it using the tips from below links. Now, Unraid is a proprietary Linux -based operating system designed to run on home servers in order to operate as a network-attached storage (NAS) device, So, I think the idea of why this happens is it wants you to force rebuild parity into this/new drive from being emulated. You might use your system as normal A valid parity disk indicates that after the last successful parity sync, Unraid recognized the parity as "good," meaning it's suitable for data recovery if a disk . One This all started a week or two ago. After booting up, my disk 5 says: Unmountable: Unsupported or no file system If I boot with the disk with that status or if I Howdy folks! 👋 The last time I had a disk in a similar state, I rushed things, screwed up and lost 3TB of media Do'h 🤦‍♂️ So I'd love to get a lovely expert's opinion on what to do next 😁 Disk 3 is Hi, After changing motherboard and CPU everything was fine until I rebooted a few times, suddenly two of the drives, Parity 1 and disk 4 are showing as Parity Device is disabled and Device is Parity sync/data rebuild has been in progress all night - about 50% done now. The disk Hi, new to the forums but have been using unraid for about 1. Copy the data over, and then rebuild the array to those 3 drives from the 12tb parity. First time it was Disk 5 and Parity 1 at the same time. qebt j7 my tms7s amf duqh rahj1 uo8wp xa 9ibgas